QX95 95MM Racing Quadcopter

QX95 95MM Racing Quadcopter
  • QX95 95MM Racing Quadcopter
  • QX95 95MM Racing Quadcopter
  • QX95 95MM Racing Quadcopter
  • QX95 95MM Racing Quadcopter

Mini QX95 95mm carbon fiber Quadcopter Frame Kit + 8520 8.5*20 Coreless Motor + F3 EVO V2.0 / CC3D brush board + 1000TVL camera

  • Product No.: 2017717161430


Package included:

1 x QX95 Frame Kit (just a frame kit, not assembled)
1 x F3 EVO V2.0 brushed board
1 x 5.8G 25mW Transmitter With 1000TVL Camera and Antenna
1 x Mini  DSM2  receiver
4 x 8520 motor(2pcs CW, 2pcs CCW)
4pair 55mm propeller

QX95 frame Description: 
Item Name: DIY Frame Kit
Item NO.: QX95
Material: Carbon Fiber
Wheelbase: 95mm
Upper plate thickness:1mm
Bottom plate thickness:1.5mm
Net Weight:  8.9g
Motor size: 8.5x20mm
Micro 32bits F3 EVO V2.0 Brushed 3g Flight Control Board

The latest version F3_EVO_BRUSHED brush flight control support 6-axis aircraft, operating current of each shaft can be up to 10A or above, improved blood pressure booster module, can reach to 500mah constand current output by using UART1 or UART2 output 5V, can meet the low-power diagram as 25mw FPV camera, support LED_STRIP function.



1, the propeller must be removed before doing brush flight control program or calibration;
2, flight control by default brush F3 EVO 1.13.0 programs, if you want re-brush firmware, please write "set motor_pwm_rate=1000" in the CLI command control line of CF configuration software , and enter the "Save" command to save!
3. Set the throttle set the maximum value of 2000, can effectively increase the flight time.
SP Racing F3 EVO Brush Flight Controller Specifiations:
Dimension: 22mm*32.5mm
Thickness: 1.2mm
Weight: 3g
Receiver configuration:
1. DSM DSM receiver soldered directly to the interface 3.3V, GND, RX3, CF the software configuration UART3.
2. PPM and SBUS receiver welded to the UART2 GND, + 5V, RX2 above, SBUS signal CF in the software configuration.
Before applying power, pay attention to the battery voltage selection:
The default shipping is 1S (4.2V); 
2S first need to disconnect the short contacts 1S, 2S and then connect two pads short. 
Prohibit the same three pads shorted together.

8520 motor Description:


Motor Diameter: 8.5mm

Motor Length: 20mm

Shaft Diameter: 1.0mm

Cable Length: 60mm

Option: Clockwise Motor(With Red Blue), Anti-clockwise Motor(With Black White)

This 8520 coreless motor support 2S battery 





1000TVL  FPV Camera description:


Sensor : 1/3" COMS

Lens :1000TVL



Power consumption:200mA@5V

Power :5V

Lens Mirror Diameter:2.9mm



Support video format :PAL

Output Impedance: 50 Ohm

Output signal strength: 13±1dbmdBm

Output Power: 25mW 

Wireless Channel: 48CH

Operating voltage: 5V

Current: 100mA

Audio carrier: 6.5MHz

Frequency : 5 BAND 48CH 5645 ~ 5945 MHz



1. Micro Size and Light weight

2. Easy installation for racing drone

3.48 channels

4.Wide voltage range , can use 1s , 2s power battery directly , no need extra battery



  • * (All * must be filled in)

Related Products