Pixhawk 2.4.7 Full Combo Set
Description:
PX4 Pixhawk V2.4.7 32Bits Open Source Flight Controller w/External LED for RC Airplanes
Improvements on V2.4.6
- V2.4.7 PCB board
- Improve the design (make RGB LED stable and less heating,make control more stable,improve the power supply of sensor )2.4.7
- solve some bugs.(Such as ACC report problems)
Features:
- 168 MHz / 252 MIPS Cortex-M4F
- 14 PWM / Servo outputs (8 with failsafe and manual override, 6 auxiliary, high-power compatible)
- Abundant connectivity options for additional peripherals (UART, I2C, CAN)
- Integrated backup system for in-flight recovery and manual override with dedicated processor and stand-alone power supply (fixed-wing use)
- Backup system integrates mixing, providing consistent autopilot and manual override mixing modes (fixed wing use)
- Redundant power supply inputs and automatic failover
- External safety switch
- Multicolor LED main visual indicator
- High-power, multi-tone piezo audio indicator
- microSD card for high-rate logging over extended periods of time
- Redeveloped and optimized circuit without changing components
- Could use Official MissionPlanner, ECLIPSE firmware upgrade
Specifications:
Processor
- 32bit STM32F427 Cortex M4 core with FPU
- 168 MHz
- 256 KB RAM
- 2 MB Flash
- 32 bit STM32F103 failsafe co-processor
Sensors
- ST Micro L3GD20H 16 bit gyroscope
- ST Micro LSM303D 14 bit accelerometer / magnetometer
- MEAS MS5611 barometer
Interfaces
- 5x UART (serial ports), one high-power capable, 2x with HW flow control
- 2x CAN (one with internal 3.3V transceiver, one on expansion connector)
- Spektrum DSM / DSM2 / DSM-X® Satellite compatible input
- Futaba S.BUS® compatible input and output
- PPM sum signal input
- RSSI (PWM or voltage) input
- I2C
- SPI
- 3.3 and 6.6V ADC inputs
- Internal microUSB port and external microUSB port extension
Power System and Protection
- Ideal diode controller with automatic failover
- Servo rail high-power (max. 10V) and high-current (10A+) ready
- All peripheral outputs over-current protected, all inputs ESD protected
Components: D1002 and F1002
- D1002 model: PMEG2005CT
- This version of flight control can solve the problem of small supply current for receiver, and the flight control system halted caused by overcurrent supply
Package Included:
- PX4 V2.4.7 Flight board x1(with origianl DF13 connector )
- Safety switch x1
- Buzzer x1
- Original Case x1
- 8GB SD Card x1
- SD Card Adapter x1
- External LED light board X 1
- PPM Module x1
- Pixhawk-I2C Splitter Expand Module X 1
- Neo-M8N Gps Module x1
- Black Gps Holder x1
- Power Module x1
- Minim OSD x1
- 433/915 MHZ telemetry x1 ( send by your choice)
- DF13 4Pin Cable x1
- DF13 5Pin Cable x1
- DF13 6Pin Cable x1
